PriceList for Membrane Pressure - UF Membrane Module PVC Ultrafiltration Membrane Module UFc50C Stainless Steel Housing Household Water Purification – Bangmo
PriceList for Membrane Pressure - UF Membrane Module PVC Ultrafiltration Membrane Module UFc50C Stainless Steel Housing Household Water Purification – Bangmo Detail:
Product?Overview
UFc50C? is? capillary? hollow? fiber? membrane? made? of? high? polymer? material, which is a separating product that will not have any phase change. The modified PVC material adopted to this product has good permeable rate, good mechanical strength, good? chemical? resistance? anti-pollution? ability,? MWCO? is? 100k? Dalton.? Membrane ID/OD? is? 1.0mm/1.8mm, ?filtering? direction? is? inside-out,? that? is? raw? water? flows inside the hollow fibers and, driven by differential pressure, permeates outwards so as to filter? bacteria, colloids, suspended substances,? microbes, and other? harmful substances.
Applications
Production of mineral water, mountain spring water and other germ-free liquid;
Drinking treatment of tap?water, surface?water, well?water?and?river?water;
Pre-treatment?of?RO?device;
Treatment, recycle and reuse of industrial wastewater
Filtration?Performance
According to the service conditions of modified PVC hollow fiber ultrafiltration membrane which? are? applied to various water? sources, the? product? is? proved to reach below filtration effects:
| Water?Composition | Filtering?Effect |
| Suspended Substances, Particles >1um | Removal Rate ≥99% |
| SDI | ≤?3 |
| Virus, Bacteria | >4 log |
| Turbidity | <0.1NTU |
| TOC | Removal Rate?0-25% |
Above data is obtained when turbidity of feed water is less than 15NTU. The product? is? proved? to? reach? the? sanitary? standards? of? drinking? water? by ?Health Department? of? Guangdong? Province.? Approval? number? is? YUE? WEI? SHUI? ZI? 2014S1671.
Product?Parameters
Product?Appearance
Figure 1 Product Dimensions
Inner?Filter
Figure 2 Inner Filter Dimensions
Technical?Parameters:
| Structure | Inside-out |
| Membrane?Material | Modified?PVC |
| MWCO | 100K Dalton |
| Nominal Membrane Area | 5.4m |
| Membrane?ID/OD | 1.0mm/1.8mm |
| Module Dimensions | Φ105mm×?1110mm |
| Connector Dimensions | 3/4” Female Thread |
Application?Data:
| Pure?Water?Flux | 1,700L/H (0.15MPa, 25oC) |
| Designed?Flux | 35-100L/H (0.15MPa, 25oC) |
| Operating?Pressure | ≤0.2MPa |
| Maximum Trans Membrane?Pressure | 0.2MPa |
| Maximum Operating Temperature | 45oC |
| Operating PH Range | 4-10 |
| Washing PH Range | 2-12 |
| Operating?Mode | Cross-flow/Dead-end Filtration |
Feed?Water Requirements:
A security filter, precision <50 micron, should be set as pretreatment of UF, in case of? blockage caused? by? large? particles? in? raw water. Attention:? UF? membrane material is macromolecular organic plastics, raw water must not contain any organic solvents.
| Feed?Water?Turbidity | ≤15NTU |
| Oil & Grease | ≤2mg/L |
| Feed?Water?SS | ≤20mg/L |
| Total?Iron | ≤1mg/L |
| Continuous Feeding Residual Chlorine | ≤5ppm |
| COD | Suggested ≤500mg/L |
Component?Material:
| Component | Material |
| Hollow?Fiber?Membrane | Modified?PVC |
| Potting Material | Epoxy?Resins |
| Membrane?Housing | SUS304 |
Typical?Operating?Parameters:
| Maximum Backwashing Pressure | 0.2MPa | |
| Backwashing?Flow?Rate | 100-150L/m2 .h | |
| Backwashing?Frequency | Every?30-60 minutes | |
| Backwashing?Duration | 30-60 seconds | |
| CEB Frequency | 0-4 times/day | |
| CEB Duration | 5-10 minutes | |
| CIP Frequency | 1-3 months | |
| General Washing Chemicals ： | ||
| Disinfection | 15ppm NaClO | |
| Organic?Contamination?Washing | 0.2% NaClo+0.1% NaOH | |
| Inorganic?Contamination?Washing | 1-2% Citric Acid /0.2% HCl | |
Product detail pictures:
Related Product Guide:
we can offer high quality products, competitive price and customer service. Our destination is You come here with difficulty and we give you a smile to take away for PriceList for Membrane Pressure - UF Membrane Module PVC Ultrafiltration Membrane Module UFc50C Stainless Steel Housing Household Water Purification – Bangmo , The product will supply to all over the world, such as: New Delhi, Haiti, Philadelphia, Our company has built stable business relationships with many well-known domestic companies as well as oversea customers. With the goal of providing high quality products to customers at low cots, we are committed to improving its capacities in research, development, manufacturing and management. We have honored to receive recognition from our customers. Till now we have passed ISO9001 in 2005 and ISO/TS16949 in 2008. Enterprises of quality of survival, the credibility of development for the purpose, sincerely welcome domestic and foreign businessmen to visit to discuss cooperation.
By Jason from USA - 2018.11.04 10:32
The factory technical staff gave us a lot of good advice in the cooperation process, this is very good, we are very grateful.
By Jocelyn from Surabaya - 2018.06.18 17:25
