China Factory for Ultrafiltration Membrane Material - UF Membrane Module 9 inch PVDF Ultrafiltration Membrane Module UFf2860 Replacing Project – Bangmo
China Factory for Ultrafiltration Membrane Material - UF Membrane Module 9 inch PVDF Ultrafiltration Membrane Module UFf2860 Replacing Project – Bangmo Detail:
Applications
Drinking treatment of tap water, surface water, well water and river water.
Pretreatment of RO.
Treatment, recycle and reuse of industrial waste water.
Filtration Performance
This product is proven to have below filtering effects according to the service?conditions of different water sources:
| Ingredient | Effect |
| SS, Particles?> 1μm | Removal Rate?≥ 99% |
| SDI | ≤ 3 |
| Bacteria, Viruses | >?4 log |
| Turbidity | < 1NTU |
| TOC | Removal Rate: 0-25% |
*Above data is obtained under the condition that feeding water turbidity is < 25NTU.
Product Parameters
Technical Parameters
| Filtering?Type | Outside-in |
| Membrane?Material | Modified?PVDF |
| MWCO | 200K Dalton |
| Membrane?Area | 52m2 |
| Membrane?ID/OD | 0.8mm/1.3mm |
| Dimensions | Φ225mm* 1860mm |
| Connector?Size | DN50 Clamping; Air?Inlet?– 10mm?air?pipe |
Application Data
| Pure?Water?Flux | 8,000L/H?(0.15MPa, 25C) |
| Designed?Flux | 40-120L/m2.hr?(0.15MPa, 25C) |
| Suggested?Working?Pressure | ≤ 0.2MPa |
| Maximum?Transmembrane?Pressure | 0.15MPa |
| Maximum?Backwashing?Pressure | 0.15MPa |
| Air?Washing?Volume | 0.1-0.15N m3/m2 .hr |
| Air?Washing?Pressure | ≤ 0.1MPa |
| Maximum?Working?Temperature | 45C |
| PH?Range | Working: 4-10; Washing: 2-12 |
| Operating?Mode | Cross?Flow?or Dead End |
Feeding Water Requirements
Before feeding water, a security filter < 50 μm should be set to prevent blockage caused?by large particles in raw water.
| Turbidity | ≤ 25NTU |
| Oil?&?Grease | ≤?2mg/L |
| SS | ≤ 20mg/L |
| Total?Iron | ≤?1mg/L |
| Continuous?Residual?Chlorine | ≤?5ppm |
| COD | Suggested?≤ 500mg/L |
*Material of UF membrane is polymer organic plastic, there must not be any organic solvents in raw water.
Operating Parameters
| Backwashing?Flow?Rate | 100-150L/m2.hr |
| Backwashing?Frequency | Every?30-60min. |
| Backwashing?Duration | 30-60s |
| CEB?Frequency | 0-4?times per day |
| CEB?Duration | 5-10min. |
| CIP?Frequency | Every 1-3 months |
| Washing?Chemicals: | |
| Sterilization | 15ppm Sodium Hypochlorite |
| Organic?Pollution?Washing | 0.2%?Sodium Hypochlorite + 0.1% Sodium Hydroxide |
| Inorganic?Pollution?Washing | 1-2% Citric?Acid/0.2% Hydrochloric?Acid |
Component Material
| Component | Material |
| Membrane | Modified?PVDF |
| Sealing | Epoxy?Resins |
| Housing | UPVC |
Product detail pictures:
Related Product Guide:
We depend on sturdy technical force and continually create sophisticated technologies to meet the demand of China Factory for Ultrafiltration Membrane Material - UF Membrane Module 9 inch PVDF Ultrafiltration Membrane Module UFf2860 Replacing Project – Bangmo , The product will supply to all over the world, such as: Swiss, Angola, Anguilla, We always insist on the principle of Quality and service are the life of the product. Till now, our products have been exported to more than 20 countries under our strict quality control and high level service.
By Marcie Green from panama - 2018.04.25 16:46
We have been appreciated the Chinese manufacturing, this time also did not let us disappoint,good job!
By Belinda from Israel - 2018.06.12 16:22
Write your message here and send it to us
